Skip to main content
Skip table of contents

Configure thermal printer products

For thermal printer supply management to operate correctly on the NDD Orbix portal, it is essential that all products are properly registered and identified.

Initially, demand generation and exchange identification will be based on the supply's production indicator. Therefore, it is essential to correctly inform the actual capacity of each product in the registration.

They can also be identified based on the level indicator, provided that the supply provides this information.

There are two ways to register products in the system:

The capacity obtained via reading will always be recorded as 0 (indeterminate), as thermal printer supplies do not have this data.

Product capacity must be entered using one of the following options:

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.